Home > Resin and Filter Media >

Birm, Regular 1/2 Cubic Foot Box
BIRM-R-50-BOX
BIRM-R-50-BOX


 
Alternative Views:


Please contact ForeverPure for Pricing. (Call 408-969-2688 ext. 1 for Sales Department)




Product Code: BIRM-R-50-BOX
Qty:

Description Spec Sheet / Manual
 
Birm, Regular 1/2 Cubic Foot Box

Birm® is an efficient and economical method of removing dissolved iron and manganese compounds from raw water supplies. It may be used in either gravity fed or pres­sur­ized water treatment systems. Birm® acts as an insoluble catalyst to enhance the reaction between dissolved ox­y­gen (D.O.) and the iron compounds. In ground waters, the dissolved iron is usually in the ferrous bicarbonate state due to an excess of free carbon dioxide and is not filterable. Birm®, acting as a catalyst between the oxygen and the soluble iron com­pounds, enhances the oxidation reaction of Fe++ to Fe+++ and produces ferric hydroxide which precipitates and may be easily filtered. The phys­i­cal characteristics of Birm® provide an excellent filter media which is easily cleaned by back washing to remove the precipitant. Birm® is not consumed in the iron removal and therefore offers a tremendous economic advantage over many other iron removal methods.

Birm® may also be used for manganese removal with the same dependability as iron removal. In these ap­pli­ca­tions the water to be treated should have a pH of 8.0 to 9.0 for the best results. If the water also contains iron, the pH should be below 8.5. High pH conditions may cause the formation of colloidal iron which is very difficult to filter out. All other conditions remain the same for either manganese or iron removal.

Birm is used to remove dissolved iron and manganese. The pH must be above 6.8 and dissolved oxygen content must be equal to 15% of the iron and manganese content. No regeneration is required, only periodic backwashing.

Advantages:
  • Under the proper conditions, no chemicals to purchase for maintenance. Regeneration not required.
  • Iron removal efficiency is extremely high
  • Negligible Labor Cost - only periodic back washing required
  • Durable material with a long life and wide temperature range
  • Weighs only 46-50 lb./cubic foot.

Physical Properties:
  • Color: Black
  • Density: 47-50 lbs./cu. ft.
  • Effective Size: 0.61 mm
  • Uniformity Coefficient: 1.72


Conditions for Operation:

  • Alkalinity should be greater than two times the combined sulfate and chloride concentration
  • pH - 6.8+
  • Dissolved Oxygen (D.O.) content must be equal to at least 15% of the iron (or iron and manganese content)
  • Bed Depth - 30 - 36 in.
  • Backwash Rate - 10-12 gpm. sq. ft.
  • Backwash Bed Expansion - 35 -50% of bed depth
  • Service Flow rate - 3.5 - 5 gpm. sq. ft. intermittent flow rates and/or favorable conditions may allow higher flow rates

Share your knowledge of this product. Be the first to write a review »