Home > Membranes - RO/UF/NF > Filmtec >

Filmtec TW30-2540 DOW Reverse Osmosis Membrane
Filmtec TW30-2540 DOW Reverse Osmosis Membrane


 
Filmtec TW30-2540 DOW Reverse Osmosis Membrane
Our Price: $188.00



Availability:: Usually Ships in 3 to 5 Days
Product Code: TW30-2540
Qty:

Description Spec Sheet / Manual Technical Specifications
 

FilmTec™ TW30-2540


FilmTec™ TW30-2540 Elements are the industry standard for reliable operation and production of the highest quality water in commercial applications. FilmTec TW30-2540 elements are tape-wrapped—built with the same high quality membranes and materials of construction as industrial elements, except for the hard outershell, and are more economical for commercial systems with one or two elements per housing. It may be cleaned over a wide pH range (pH 1 – 13) for the most effective cleaning.

FilmTec™ Brackish Water Reverse Osmosis < 4" Elements can separate salts from water and are produced with an automated fabrication process for precision, consistency, and reliability. They are ideal for use in small-sized water treatment systems that produce less than approximately 1 gpm (230 L/h) of permeate. Our RO membranes build on a tradition of leadership in the thin-film composite membrane industry and meet the challenges of higher rejection in lower-pressure operations.


Uses


Advantages

Typical Properties

Operating and Cleaning Limits
Membrane TypePolyamide Thin-Film Composite
Maximum Operating Temperature113°F (45°C)
Maximum Operating Pressure600 psig (41 bar)
Maximum Pressure Drop13 psig (0.9 bar)
pH Range, Continuous Operation2-11
pH Range, Short-T erm Cleaning (30 min.)1-13
Maximum Feed Silt Density Index (SDI)SDI 5
Free Chlorine Tolerance< 0.1ppm
a. Maximum temperature for continuous operation above pH 10 is 95°F (35°C).

b. Refer to Cleaning Guidelines in specification sheet 609-23010.
c. Under certain conditions, the presence of free chlorine and other oxidizing agents will cause premature membrane failure. Since oxidation damage is not covered under warranty, it is recommended that residual free chlorine be removed by pretreatment prior to membrane exposure. Please refer to technical bulletin 609-22010 for more information

We are a volume seller of FilmTec and Hydranautics membranes. Please contact use for large quantity discounts.


Share your knowledge of this product. Be the first to write a review »